Removal and Installation

All vehicles 

1. Remove the LH and RH floor console upper finish moulding. For additional information, refer to the EDGE FLOOR CONSOLE FINISH PANELS .

   Edge 

2. Place the transmission selector lever in neutral.
3. NOTE: The floor console selector lever panel does not need to be removed.

   Remove the 4 screws, detach the 2 clips and position the floor console selector lever trim panel back.

4. Remove the 6 Front Controls Interface Module (FCIM) screws and remove the FCIM  .
   • Disconnect the electrical connector.

   MKX 

5. Remove the two screws at the lower LH and RH corners of the of the FCIM  .
6. Pull back on the FCIM  starting at the bottom and working to the top to release the clips. Remove the FCIM  .
   • Disconnect the electrical connector.

   All vehicles 

7. To install, reverse the removal procedure.