Electronic Power Assist Steering (EPAS) System

The Electronic Power Assist Steering (EPAS) system provides power steering assist to the driver by replacing the conventional hydraulic valve system with an electric motor coupled to the steering rack by a toothed belt. The motor is controlled by the Power Steering Control Module (PSCM) that senses steering effort/use through the use of a torque sensor which is mounted near the input shaft of the steering gear. Steering assist is provided in proportion to the steering input effort and vehicle speed.

The EPAS  system requires a 12-volt, hot at all times feed for system operation. The PSCM  is activated when power is applied to the hard-wired ignition/run input. After activation, the PSCM  monitors the High Speed Controller Area Network (HS-CAN) bus to determine if the vehicle is operating in a manner capable of supporting the EPAS  system.

Once this is determined, vehicle speed sent by the PCM over the HS-CAN  bus, steering shaft speed and direction sent by the torque sensor and steering wheel angle/position determined by the motor position all provide the necessary information for the PSCM  to determine the amount or level of assist provided by the EPAS  system.

Assist is primarily based off of vehicle speed. As vehicle speed increases, the amount of assist provided by the system is decreased to improve and enhance road feel at the steering wheel. As vehicle speed decreases, the amount of assist provided by the system is increased to ease vehicle maneuvering. If the vehicle speed is missing or out of range, the PSCM  defaults to a safe level of assist for all driving conditions. If the vehicle speed returns to the correct in-range values, the PSCM  will adjust the level of assist accordingly. Steering wheel/shaft speed, torque and direction information will allow the PSCM  to determine how much assist is needed to turn the wheels right and left.

The PSCM  is self-monitoring and has the capability of setting and storing DTCs. Depending on the DTC set, the control module will enter into a "safe mode" of manual steering. In addition, the PSCM  may send a request to the Instrument Panel Cluster (IPC) module over the HS-CAN  bus to display a message in the message center to alert the driver of a potential EPAS  concern.