| B00D5:01 |
Restraint System Passenger Disable Indicator: General Electrical Failure |
CLEAR the DTCs. WAIT 10 seconds. REPEAT the self-test. If DTC B00D5:01 is still present, INSTALL a new Front Controls Interface Module (FCIM). REFER to FRONT CONTROLS INTERFACE MODULE (FCIM) . |
| B113C:11 |
Hazard Switch Illumination: Circuit Short To Ground |
CLEAR the DTCs. WAIT 10 seconds. REPEAT the self-test. If DTC B113C:11 is still present, INSTALL a new Front Controls Interface Module (FCIM). REFER to FRONT CONTROLS INTERFACE MODULE (FCIM) . |
| B1202:01 |
Restraint System Passenger Enable Indicator: General Electrical Failure |
CLEAR the DTCs. WAIT 10 seconds. REPEAT the self-test. If DTC B1202:01 is still present, INSTALL a new FCIM. REFER to FRONT CONTROLS INTERFACE MODULE (FCIM) . |
| U0155:00 |
Lost Communication With Instrument Panel Cluster (IPC) Control Module: No Sub Type Information |
GO to PINPOINT TEST Z . |
| U0423:00 |
Invalid Data Received From Instrument Panel Cluster Control Module: No Sub Type Information |
REFER to
INSTRUMENTATION, MESSAGE CENTER, AND WARNING CHIMES
, IPC DTC Chart to RETRIEVE and FOLLOW DTCs present in the IPC. |
| U0257:00 |
Lost Communication With Front Controls/Display Interface Module: No Sub Type Information |
GO to PINPOINT TEST AB . |
| U2013:63 |
Switch Pack: Circuit/Component Protection Time-Out |
GO to PINPOINT TEST G . |
| U3000:41 |
Control Module: General Checksum Failure |
CLEAR the DTCs. WAIT 10 seconds. REPEAT the self-test. If DTC U3000:41 is still present, INSTALL a new FCIM. REFER to FRONT CONTROLS INTERFACE MODULE (FCIM) . |
| U3000:42 |
Control Module: General Memory Failure |
CLEAR the DTCs. WAIT 10 seconds. REPEAT the self-test. If DTC U3000:42 is still present, INSTALL a new FCIM. REFER to FRONT CONTROLS INTERFACE MODULE (FCIM) . |
| U3003:16 |
Battery Voltage: Circuit Voltage Below Threshold |
GO to PINPOINT TEST AF . |
| U3003:17 |
Battery Voltage: Circuit Voltage Above Threshold |
GO to PINPOINT TEST AG . |