LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2013 >> MKS EcoBoost >> Repair and Diagnosis >> External Pages >> Different car >> Section 249 (Rear Disc Brake System) >> Removal And Installation >> Rear Disc Brake >> Installation

Rear Disc Brake: Installation

WARNING: This page is about a different car, the 2013 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
  1. Clean any rust or foreign material from the brake disc and the wheel hub.
    • Use the specified brake parts cleaner to clean the brake disc and hub surfaces.
  2. NOTE: In order for the brake caliper anchor plate bolts to attain the proper clamp load when installed, the residual threadlock compound must be cleaned out of the bolt threads of the anchor plate.

    Clean any residual threadlock compound, and any other foreign material, from the threads of the brake caliper anchor plate.

  3. NOTE: Do not allow the lubricant to make contact with the wheel studs, brake pads or brake disc or damage to components may occur.

    Apply a thin coat of the specified anti-seize lubricant to the hub flange.

  4. Position the brake disc onto the wheel hub.
  5. Position the brake caliper anchor plate and install 2 new anchor plate bolts.
    • Tighten to 103 Nm (76 lb-ft).
  6. Install the wheel and tire. For additional information, refer to WHEELS AND TIRES .
    • Apply brakes several times to verify correct brake operation.
scientia non olet · About LEMON Manuals