Transaxle Support Insulator - Anti-Roll: Installation

Clean the roll restrictor through bolts using a wire brush and apply new threadlock to the threads.
Position the roll restrictor in place, install the roll restrictor-to-transaxle bracket through bolt and the roll restrictor-to-subframe through bolt.
- Tighten to 115 Nm (85 lb-ft).
  
  Fig 1: Locating Roll Restrictor Through Bolts
  Courtesy of FORD MOTOR CO.
Install the roll restrictor heat shield and the roll restrictor heat shield nuts.
- Tighten to 9 Nm (80 lb-in).
  
  Fig 2: Locating Roll Restrictor Heat Shield Nuts
  Courtesy of FORD MOTOR CO.
Install the exhaust Y-pipe. For additional information, refer to EXHAUST SYSTEM .