Front Disc Brake: Installation
WARNING: This page is about a different car, the 2013 Lincoln MKX and 2013 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
- Using the specified brake parts cleaner, clean and dry the brake disc-to-wheel hub mounting surface, then apply a thin coat of the specified anti-seize where indicated.
- Install the brake disc.
- Position the brake caliper and anchor plate assembly and the brake caliper anchor plate bolts.
- Tighten to 133 Nm (98 lb-ft).
- Install the wheel and tire. For additional information, refer to
WHEELS AND TIRES
.
- Apply brakes several times to verify correct brake operation.
NOTE:
Do not apply anti-seize to wheel studs or incorrect tightening of the wheel nuts may occur.
NOTE:
Make sure the brake disc is clean and free of any foreign material.