LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2011 >> MKZ Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1644 (Automatic Transaxle - 6F35 - Disassembly, Disassembly And Assembly Of Subassemblies, Assembly, Installation) >> Disassembly And Assembly Of Subassemblies >> Clutch Support Tower >> Assembly

Clutch Support Tower: Assembly

WARNING: This page is about a different car, the 2011 Mercury Milan and 2011 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the Input Shaft Support Seal Installer 307-578/3 on the clutch support tower and adjust the Input Shaft Support Seal Installer to align the bottom edge of the tool with the top edge of the bottom Teflon® seal groove.
    Fig 1: Identifying Input Shaft Support Seal Installer 307-578/3
    G07783244Courtesy of FORD MOTOR CO.
  2. Install a new Teflon® seal on the Input Shaft Support Seal Installer 307-578/3.
    Fig 2: Identifying Teflon® Seal On Input Shaft Support Seal Installer 307-578/3
    G07783245Courtesy of FORD MOTOR CO.
  3. Install the Input Shaft Support Seal Installer 307-578/2 over 307-578/3. Using the Input Shaft Support Seal Installer 307-578/2, slide the Teflon® seal over the clutch support tower and into the groove.
    Fig 3: Sliding Teflon® Seal Over Clutch Support Tower
    G07783246Courtesy of FORD MOTOR CO.
  4. Remove the Input Shaft Support Seal Installer 307-578/2 and 307-578/3.
    • Repeat Steps  1 through  4 for the other 3 Teflon® seals.
      Fig 4: Identifying Input Shaft Support Seal Installer 307-578/2 And 307-578/3
      G07783247Courtesy of FORD MOTOR CO.
  5. Install the Input Shaft Support Seal Installer 307-578/1 on the clutch support tower to size the 4 Teflon® seals.
    Fig 5: Identifying Input Shaft Support Seal Installer 307-578/1
    G07783248Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals