Removal and Installation

All vehicles 

1. Remove the LH and RH floor console upper finish moulding. For additional information, refer to the floor console exploded view in INSTRUMENT PANEL AND CONSOLE .

   Edge 

2. Place the transmission selector lever in neutral.
NOTE: The floor console selector lever panel does not need to be removed.
3. Remove the 4 screws, detach the 2 clips and position the floor console selector lever trim panel back.
4. Remove the 6 Front Controls Interface Module (FCIM) screws and remove the FCIM  .
   • Disconnect the electrical connector.

   MKX 

5. Remove the two screws at the lower LH and RH corners of the of the FCIM  .
6. Pull back on the FCIM  starting at the bottom and working to the top to release the clips. Remove the FCIM  .
   • Disconnect the electrical connector.

   All vehicles 

7. To install, reverse the removal procedure.