LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2010 >> MKZ AWD >> Repair and Diagnosis >> Engine Mechanical >> Exhaust System >> General Procedures >> Torca® Clamp

Torca® Clamp

  1. Remove the nut from the Torca® clamp.
  2. Grind the spot weld from the Torca® clamp and remove the clamp.
  3. Clean the uneven surface area and position a Torca® clamp.
    Fig 1: Positioning Torca® Clamp
    G06270947Courtesy of FORD MOTOR CO.
  4. Make sure the back of the slot is covered by the clamp and the button is fully seated inside the notch.
    NOTE: Make sure the clamp position is no more than 27.5 mm (1.08 in) or less than 25.5 mm (1 in) from the inlet of the resonator pipe.
    Fig 2: Identifying Clamp Position
    G06270948Courtesy of FORD MOTOR CO.
  5. Tighten the Torca® clamp.
    • Tighten to 47 Nm (35 lb-ft).
    NOTE: Do not tighten the clamp until the exhaust system has been aligned.
scientia non olet · About LEMON Manuals