Audio Control Module (ACM) DTC List
Audio Control Module (ACM) DTC List
| DTC | Description | Action |
|---|---|---|
| B119F:01 | GPS Antenna: General Electrical Failure | Go To PINPOINT TEST T . |
| B119F:13 | GPS Antenna: Circuit Open | Go To PINPOINT TEST T . |
| B11BA:1C | Steering Wheel Audio Switch Pack: Circuit Voltage Out of Range | Go To PINPOINT TEST M . |
| B11BA:63 | Steering Wheel Audio Switch Pack: Circuit / Component Protection Time-Out | Go To PINPOINT TEST M . |
| B1201:1C | Steering Wheel Audio Switch Pack 2: Circuit Voltage Out of Range | Go To PINPOINT TEST M . |
| B1201:63 | Steering Wheel Audio Switch Pack 2: Circuit / Component Protection Time-Out | Go To PINPOINT TEST M . |
| B121C:01 | Hard Drive: General Electrical Failure | CLEAR the DTCs. REPEAT the self-test. If DTC B121C:01 is retrieved again, INSTALL a new Audio Control Module (ACM). refer to AUDIO CONTROL MODULE (ACM) . REPEAT the self-test. |
| B1A05:01 | Speaker #5: General Electrical Failure | For Premium sound, Go To PINPOINT TEST B
. For THX® sound, Go To PINPOINT TEST C . |
| B1A06:01 | Speaker #6: General Electrical Failure | For Premium sound, Go To PINPOINT TEST B
. For THX® sound, Go To PINPOINT TEST C . |
| B1A07:01 | Speaker #7: General Electrical Failure |
NOTE:
This DTC is only applicable for vehicles with navigation, as it applies to the navigation voice circuits to the audio Digital Signal Processing (DSP) module. Go To PINPOINT TEST V
. |
| B1A56:21 | Antenna: Signal Amplitude < Minimum | Go To PINPOINT TEST A . |
| B1A89:01 | Satellite Antenna: General Electrical Failure | Go To PINPOINT TEST S . |
| B1A89:13 | Satellite Antenna: Circuit Open | Go To PINPOINT TEST S . |
| B1D19:49 | Compact Disc Unit: Internal Electronic Failure | CLEAR the DTCs. REPEAT the self-test. If DTC B1D19:49 is retrieved again, INSTALL a new ACM . refer to AUDIO CONTROL MODULE (ACM) . REPEAT the self-test. |
| B1D19:4B | Compact Disc Unit: Over Temperature | The ACM was over-temperature. This may occur during extended use. Audio operation can resume after the ACM cools. CLEAR the DTCs. This is normal operation. |
| B1D79:01 | Microphone Input: General Electrical Failure | Go To PINPOINT TEST Q . |
| C1001:01 | Vision System Camera: General Electrical Failure | Refer to PARKING AID . |
| U0140:00 | Lost Communication With Body Control Module: No Sub Type Information | Go To PINPOINT TEST AE . |
| U0155:00 | Lost Communication With Instrument Panel Cluster (IPC ) Control Module: No Sub Type Information | Go To PINPOINT TEST AS . |
| U0162:00 | Lost Communication With Navigation Display Module: No Sub Type Information | Go To PINPOINT TEST J . |
| U0164:00 | Lost Communication With HVAC Control Module: No Sub Type Information | Go To PINPOINT TEST AJ . |
| U0196:00 | Lost Communication With Entertainment Control Module-Rear "A": No Sub Type Information | Go To PINPOINT TEST AU . |
| U0197:00 | Lost Communication With Telephone Control Module: No Sub Type Information | Go To PINPOINT TEST AQ . |
| U0238:00 | Lost Communication With Digital Audio Control Module "D": No Sub Type Information | Go To PINPOINT TEST AR . |
| U0256:00 | Lost Communication With Front Controls Interface Module: No Sub Type Information | Go To PINPOINT TEST AX . |
| U2014:09 | Control Module Hardware: Component Failure | Go To PINPOINT TEST U . |
| U2014:41 | Control Module Hardware: General Checksum Failure | CLEAR the DTCs. REPEAT the self-test. If DTC U2014:41 is retrieved again, INSTALL a new ACM . refer to AUDIO CONTROL MODULE (ACM) . REPEAT the self-test. |
| U2014:96 | Control Module Hardware: Component Internal Failure | Go To PINPOINT TEST R . |
| U201A:51 | Control Module Main Calibration Data: Not Programmed | PROGRAM the ACM . refer to Programmable Module Installation (PMI) in MODULE CONFIGURATION . |
| U2100:00 | Initial Configuration Not Complete: No Sub Type Information | PROGRAM the ACM . refer to PMI in MODULE CONFIGURATION . |
| U2101:00 | Control Module Configuration Incompatible: No Sub Type Information | PROGRAM the ACM . refer to PMI in MODULE CONFIGURATION . |
| U3000:45 | Control Module: Program Memory Failure | CLEAR the DTCs. REPEAT the self-test. If DTC U3000:45 is retrieved again, INSTALL a new ACM . refer to AUDIO CONTROL MODULE (ACM) . REPEAT the self-test. |
| U3003:16 | Battery Voltage: Circuit Voltage Below Threshold | Go To PINPOINT TEST AF . |
| U3003:17 | Battery Voltage: Circuit Voltage Above Threshold | Go To PINPOINT TEST AG . |