Head Up Display (HUD) Module DTC Table
NOTE:
Refer to Description and Operation, Intelligent Access (IA) with Push Button Start in INSTRUMENTATION, MESSAGE CENTER, AND WARNING CHIMES
to review the procedures for achieving the various ignition states (ignition in accessory, ignition on, ignition start, ignition off) on vehicles with this feature.
NOTE:
This module utilizes a 5-character DTC followed by a 2-character failure-type code. The failure-type code provides information about specific fault conditions such as opens, or shorts to ground. Continuous memory DTCs have an additional 2-character DTC status code suffix to assist in determining DTC history.
HEAD UP DISPLAY MODULE DTC TABLE
| DTC | Description | Action |
|---|---|---|
| U0104:00 | Lost Communication With Cruise Control Module: No Sub Type Information | Go To PINPOINT TEST B . |
| U0155:00 | Lost Communication With Instrument Panel Cluster ( IPC ) Control Module: No Sub Type Information | Go To PINPOINT TEST C . |
| U0405:68 | Invalid Data Received From Cruise Control Module: Event Information | This DTC sets when the Head Up Display (HUD) module receives invalid network data from the Cruise-Control Module (C-CM) with a faulted signal data input. RETRIEVE and REPAIR all non-network DTCs in the other modules on the network. REFER to MULTIFUNCTION ELECTRONIC MODULES for a list of all DTCs. |
| U0423:68 | Invalid Data Received From Instrument Panel Cluster Control Module: Event Information | This DTC sets when the HUD module receives invalid network data from the Instrument Panel Cluster (IPC). RETRIEVE and REPAIR all non-network DTCs in the other modules on the network. REFER to MULTIFUNCTION ELECTRONIC MODULES for a list of all DTCs. |
| U210A:16 | Temperature Sensor: Circuit Voltage Below Threshold | Go To PINPOINT TEST D . |
| U210A:17 | Temperature Sensor: Circuit Voltage Above Threshold | Go To PINPOINT TEST D . |
| U3000:41 | Control Module: General Checksum Failure | CLEAR the DTCs. REPEAT the self-test. If DTC U3000:41 is retrieved again, INSTALL a new HUD module. REFER to HEAD UP DISPLAY (HUD) MODULE . TEST the system for normal operation. |
| U3003:16 | Battery Voltage: Circuit Voltage Below Threshold | Go To PINPOINT TEST E . |
| U3003:1C | Battery Voltage: Circuit Voltage Out of Range | Go To PINPOINT TEST F . |