LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2009 >> Navigator 4WD >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission External Controls >> Removal And Installation >> Selector Lever Knob >> Installation

Selector Lever Knob: Installation

  1. Connect the Tow/Haul switch electrical connector and install the selector lever knob.
    Fig 1: Locating Tow/Haul Switch Electrical Connector
    G06127924Courtesy of FORD MOTOR CO.
  2. Install a new LH selector lever knob screw.
    • Tighten to 2 Nm (18 lb-in).
      Fig 2: Locating LH Selector Lever Knob Screw
      G06127926Courtesy of FORD MOTOR CO.
  3. Install a new RH selector lever knob screw.
    • Tighten to 2 Nm (18 lb-in).
      Fig 3: Locating Discard RH Selector Lever Knob Screw
      G06127922Courtesy of FORD MOTOR CO.
    4. NOTE: Wood-trimmed vehicles have a rubber damper not found on other trim levels.
    Fig 4: Installing LH Selector Lever Knob Cover
    G06127928Courtesy of FORD MOTOR CO.
  4. Install a new LH selector lever knob cover.
    5. NOTE: Wood-trimmed vehicles have a rubber damper not found on other trim levels.
    Fig 5: Installing RH Selector Lever Knob Cover
    G06127929Courtesy of FORD MOTOR CO.
  5. Install a new RH selector lever knob cover.
  6. Install the console upper trim and the screw.
    Fig 6: Locating Console Upper Trim And Screw
    G06127820Courtesy of FORD MOTOR CO.
  7. Install the PRNDL trim, console tray and cup holder insert.
    Fig 7: Identifying PRNDL Trim, Console Tray And Cup Holder Insert
    G06127819Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals