Easy Entry/Easy Exit

The easy exit function moves the steering column to the full upward position when the ignition key is removed from the ignition switch. The DSM  receives a key out command over the Medium Speed Controller Area Network (MS-CAN) bus and powers the steering column upward. This function will not operate if the steering column is currently at the soft stop position, between the soft stop and hard stop positions or the function has been deactivated. The DSM  will also cancel this operation if a valid input command is received, such as the power tilt column switch or memory recall request.

The DSM  will record the current steering column position before powering the steering column for an easy exit function. This recorded position will be used to return the steering column to this position on the easy entry operation. During easy entry operation, the steering column is returned to the position previous to the easy exit operation. Easy entry operation will be cancelled if a valid input command is received by the DSM  .

The easy exit/easy entry feature can be activated or deactivated using a scan tool or via the message center (if equipped). Refer to MODULE CONFIGURATION .