Front Controls Interface Module (FCIM) DTC Chart
FRONT CONTROLS INTERFACE MODULE (FCIM) DIAGNOSTIC TROUBLE CODE (DTC) LIST
| DTC | Description | Action |
|---|---|---|
| U0140:00 | Lost Communication With Body Control Module: No Sub Type Information | Go To PINPOINT TEST AB . |
| U0184:00 | Lost Communication With Radio: No Sub Type Information | Go To PINPOINT TEST F . |
| U2013:63 | Switch Pack: Circuit/Component Protection Time- Out | Go To PINPOINT TEST F . |
| U2014:41 | Control Module Hardware: General Checksum Failure | CLEAR the DTCs. REPEAT the self-test. If DTC U2014:41 is retrieved again, INSTALL a new Front Controls Interface Module (FCIM) Module. REFER to FRONT CONTROLS INTERFACE MODULE (FCIM) - WITH NAVIGATION or FRONT CONTROLS INTERFACE MODULE (FCIM) - WITHOUT NAVIGATION . REPEAT the self-test. |
| U2014:42 | Control Module Hardware: General Memory Failure | CLEAR the DTCs. REPEAT the self-test. If DTC U2014:41 is retrieved again, INSTALL a new FCIM . REFER to FRONT CONTROLS INTERFACE MODULE (FCIM) - WITH NAVIGATION or FRONT CONTROLS INTERFACE MODULE (FCIM) - WITHOUT NAVIGATION . REPEAT the self-test. |
| U201A:51 | Control Module Main Calibration Data: Not Programmed | INSTALL a new FCIM . REFER to FRONT CONTROLS INTERFACE MODULE (FCIM) - WITH NAVIGATION or FRONT CONTROLS INTERFACE MODULE (FCIM) - WITHOUT NAVIGATION . REPEAT the self-test. |
| U3003:16 | Battery Voltage: Circuit Voltage Below Threshold | Go To PINPOINT TEST AG . |
| U3003:17 | Battery Voltage: Circuit Voltage Above Threshold | Go To PINPOINT TEST AH . |