LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2007 >> MKZ FWD >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine >> In-Vehicle Servicing >> Upper Intake Manifold >> Installation

Upper Intake Manifold: Installation

  1. Using new gaskets, install the upper intake manifold and the 6 bolts.
    • Tighten in the sequence shown to 10 Nm (89 lb-in).
    2. Fig 1: Installing Upper Intake Manifold Bolts In Sequence
    GF0029082Courtesy of FORD MOTOR CO.
  2. Install the 2 upper intake manifold support bracket bolts.
    • Tighten to 10 Nm (89 lb-in).
  3. If equipped, attach the cylinder block heater wiring harness retainer to the upper intake manifold.
  4. Attach the wiring harness retainers to the upper intake manifold.
  5. Connect the PCV fitting electrical connector.
  6. Connect the PCV tube to the PCV valve.
  7. Connect the brake booster vacuum hose to the intake manifold.
  8. Connect the EVAP tube to the intake manifold. For additional information, refer to FUEL SYSTEM - GENERAL INFORMATION .
  9. Connect the throttle body electrical connector.
  10. Install the air cleaner outlet pipe. For additional information, refer to INTAKE AIR DISTRIBUTION AND FILTERING - 3.5L .
scientia non olet · About LEMON Manuals