Removal and Installation
WARNING: This page is about a different car, the 2005 Lincoln Navigator and 2005 Ford Expedition. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
The brake pedal and the accelerator pedal must be in the same position when installing a new cable or a new pedal. The pedals must be in the all the way forward or the all the way rearward position.
- Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
- Disconnect the accelerator pedal position sensor electrical connector.
- Remove the 3 nuts and the accelerator pedal assembly.
- To install, tighten to 25 Nm (18 lb-ft).
- To install, reverse the removal procedure.