LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2006 >> LS >> Repair and Diagnosis >> Engine Performance >> Remove, Overhaul & Install >> Electronic Engine Controls >> Removal And Installation >> Throttle Position (TP) Sensor >> Installation

Throttle Position (TP) Sensor: Installation

    CAUTION: Do not reuse the TP sensor and screws. A new TP sensor and screws must be installed.
    CAUTION: Do not use a high-speed driver to install the new screws or damage to the TP sensor can occur.
    NOTE: When installing the new TP sensor, make sure that the radial locator tab on the TP sensor is aligned with the radial locator hole on the throttle body.
  1. Position the TP sensor and install the 2 screws.
    • Tighten to 3 Nm (27 lb-in).
  2. Install the throttle body. For additional information, refer to FUEL CHARGING AND CONTROLS .
  3. Connect the battery ground cable. For additional information, refer to BATTERY MOUNTING AND CABLES .
scientia non olet · About LEMON Manuals