LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2006 >> LS >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine >> In-Vehicle Repair >> Exhaust Manifold - LH >> Installation

Exhaust Manifold - LH: Installation

  1. Install the 8 new exhaust manifold studs.
    • Tighten to 19 Nm (14 lb-ft).
  2. Install the new exhaust manifold gasket and the heat shield stud bolt.
    • Tighten to 50 Nm (37 lb-ft).
  3. Install the exhaust manifold and 8 new nuts.
    • Tighten to 25 Nm (18 lb-ft) in the sequence shown.
      Fig 1: Identifying Exhaust Manifold Bolts Tightening Sequence
      G04690392Courtesy of FORD MOTOR CO.
  4. Install the heat shield and 4 bolts.
    • Tighten to 3 Nm (27 lb-in).
  5. Install the lower LH splash shield and screws.
  6. Install the oil level indicator tube. For additional information, refer to OIL LEVEL INDICATOR AND TUBE .
  7. Connect the intermediate shaft to the steering gear and install the new intermediate shaft-to-steering gear bolt.
    • Tighten to 35 Nm (26 lb-ft).
  8. Tighten the intermediate shaft slider bolt.
    • Tighten to 35 Nm (26 lb-ft).
  9. Install the catalytic converters. For additional information, refer to EXHAUST SYSTEM .
scientia non olet · About LEMON Manuals