Steering System DTCS
VARIABLE ASSIST POWER STEERING MODULE DIAGNOSTIC TROUBLE CODE (DTC) LIST
| DTC | Description | Source | Action |
|---|---|---|---|
| B1317 | Battery Voltage High | VAPS Module |
NOTE:
Jump starting can set this code. CHECK the charging system. REFER to CHARGING SYSTEM - GENERAL INFORMATION
.Go to PINPOINT TEST B
. |
| C1318 | Battery Voltage Low | VAPS Module |
NOTE:
A battery in a low state of charge can set this code. CHECK the charging system. REFER to
CHARGING SYSTEM - GENERAL INFORMATION
.Go to PINPOINT TEST B
. |
| C1342 | ECU Is Defective | VAPS Module | CLEAR the DTC. REPEAT the self-test. If other DTCs are retrieved, REPAIR those DTCs first. REPEAT the self-test. If DTC B1342 is retrieved again, INSTALL a new VAPS module. |
| B2477 | Module Configuration Failure | VAPS Module | CALIBRATE the VAPS module. REFER to MODULE CONFIGURATION . |
| C1445 | Vehicle Speed Signal Circuit Failure | VAPS Module | GO to PINPOINT TEST C . |
| C1897 | Steering VAPS Circuit Loop Failure | VAPS Module | GO to PINPOINT TEST D . |
| U1026 | Invalid or Missing Data for Engine RPM | SCP | REFER to MODULE COMMUNICATIONS NETWORK |