LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2003 >> Navigator 4WD >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transaxle/Transmission >> General Procedures >> Transmission Fluid Drain And Refill >> All Vehicles Using A Suitable Flush And Fill Machine

All Vehicles Using A Suitable Flush And Fill Machine

    Draining 

  1. Position the vehicle on a hoist. Place in NEUTRAL.
  2. Use a suitable flush and fill machine to change the fluid
  3. When connecting the flush and fill machine, connect the machine to the fluid cooler line after the cooler on the cooler return line. This will help remove any debris trapped in the fluid coolers.

    4. Refill 

  4. Use only clean automatic transmission fluid.
  5. Once the fluid exchange has been completed, disconnect the flush and fill machine.

    Reconnect any disconnected fluid cooler lines.

  6. Lower the vehicle.
  7. With the engine running and the transmission at normal operating temperature 66-77°C (150-170°F), check and adjust the transmission fluid level and check for any leaks. If fluid is needed, add fluid in increments of 0.24-liter (0.5-pint) until the correct level is achieved (fluid in the cross-hatched area of the fluid level indicator).
scientia non olet · About LEMON Manuals