Door Locks: Anti-Theft
- Component Location
- Specifications
- Description And Operation
- Diagnosis And Testing
- Anti-Theft-PATS
- Notes
- Special Tool(s)
- Inspection and Verification
- Notes
- Instrument Cluster Diagnostic Trouble Code (DTC) Index
- Symptom Chart
- Connector Circuit Reference
- Pinpoint Test A: The Anti-Theft Indicator Is Never On-NO Three-Second Theft Indicator Proveout
- Pinpoint Test B: The Anti-Theft System Does Not Operate Correctly-The Vehicle Cranks But Indicator Flashes Rapidly At Key On
- Pinpoint Test C: The Anti-Theft System Does Not Operate Correctly-Anti-Theft Number Of Programmed Keys Is Below Minimum
- Pinpoint Test D: Data Mismatch (Received Data Does Not Match What Was Expected)
- Pinpoint Test E: The Anti-Theft System Does Not Operate Correctly-NVM Configuration Failure (No PCM ID Exchanged Between Instrument Cluster And PCM)
- Pinpoint Test F: The Anti-Theft System Does Not Operate Correctly-PATS Ignition Key Transponder Signal Is Not Received Or Transponder Programming Failed (Damaged Key Or Non-PATS Key)
- Pinpoint Test G: The Anti-Theft System Does Not Operate Correctly-PATS Received Incorrect Key-Code From Ignition Key Transponder (Unprogrammed PATS Key)
- Pinpoint Test H: The Anti-Theft System Does Not Operate Correctly-PATS Received Invalid Format Of Key-Code From PATS Key Transponder (Partial Key Read)
- Pinpoint Test I: The Anti-Theft System Does Not Operate Correctly-PATS Transceiver Signal Is Not Received (Not Connected, Damaged, or Wiring)
- Pinpoint Test J: The Anti-Theft System Does Not Operate Correctly-Antenna Not Connected Or Defective Transceiver
- Pinpoint Test K: The Vehicle Does Not Start-Theft Indicator Does Not Prove Out And Flashes Rapidly
- Anti-Theft-Perimeter
- Notes
- Special Tool(s)
- Inspection and Verification
- Notes
- Diagnostic Trouble Code (DTC) Index
- Symptom Chart
- Connector Circuit Reference
- Pinpoint Test L: The Anti-Theft System Does Not Operate Correctly-Lights Flash Five Times When Arming The System
- Pinpoint Test M: The Alarm System Does Not Arm/Disarm-Using The Driver Set Switch
- Pinpoint Test N: The Alarm System Does Not Arm/Disarm-Using The Remote Transmitter
- Pinpoint Test O: Battery Voltage Out Of Range-FEM
- Pinpoint Test P: Battery Voltage Out Of Range-REM
- Pinpoint Test Q: Battery Voltage Out Of Range-DDM
- Pinpoint Test R: The Alarm System Does Not Operate Correctly-Alarm Does Not Activate With Hood Ajar/Open
- Pinpoint Test S: The Alarm System Does Not Operate Correctly-Luggage Compartment Lid Disarm Switch
- Anti-Theft-PATS
- General Procedures
- Removal And Installation