Engine and Radiator Flushing: Material
WARNING: This page is about a different car, the 2003 Lincoln Town Car. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Do not open the cooling system while it is hot or the engine is running. Failure to follow these instructions may result in personal injury.
- Drain the cooling system. For additional information, see COOLING SYSTEM DRAINING, FILLING AND BLEEDING .
- Remove the water thermostat. For additional information, see THERMOSTAT .
- Install the water hose connection without the water thermostat.
- Using the an appropriate cooling system flusher, flush the engine and radiator.
Use Ford Premium Cooling System Flush VC-1 or equivalent meeting Ford specification ESR-M14P7-A. Always flush the cooling system with water thoroughly after using the VC-1 flush and prior to filling the cooling system. Always fill the cooling system with the same coolant that was present in the system. Do not mix coolant types.
- Install the water thermostat. For additional information, see THERMOSTAT .
- Backflush the heater core. For additional information, see HEATER CORE BACKFLUSHING .
- Fill the cooling system. For additional information, see COOLING SYSTEM DRAINING, FILLING AND BLEEDING .
NOTE:
Refer to the cooling system flusher manufacturer's operating instructions for specific vehicle hook-up.