Switch - Memory Set

Fig 1: Identifying Memory Set Switch Terminals

Courtesy of FORD MOTOR CO.

Remove the memory set switch.

Measure the resistance between the following indicated terminals while pressing the requested switches.

Fig 2: Memory Set Switch Reference Table

Courtesy of FORD MOTOR CO.

The resistance should be less than 5 ohms for each switch position.

If the resistance is not less than 5 ohms for each switch, install a new switch; otherwise, return to the calling pinpoint test.

Fig 3: Memory Set Switch Reference Table

Courtesy of FORD MOTOR CO.

To check the memory set switch LED, connect the positive meter lead to terminal 8 and the negative lead to terminal 9. The meter should indicate greater than 0.3 volt. Reversing the leads, the meter should read O L.

If the meter readings are not as indicated above, install a new switch; otherwise, return to the calling pinpoint test.