Accessory Delay/Power Window Relay
NOTE:
Accessory delay/power window relay is used on LTS, Signature, and Cartier models. Power window relay is used on Executive models.
- Remove relay from accessory delay/power window relay. Check relay continuity. Continuity should exist between relay terminals No. 85 and 86, and between relay terminals No. 30 and 87a. See Fig 1 . Continuity should not exist between relay terminals No. 30 and 87. If continuity is as specified, go to next step. If continuity is not as specified, replace relay.
- Using a jumper wire, apply battery voltage to relay terminal No. 85. Using a second jumper wire, ground relay terminal No. 86. Continuity should now exist between relay terminals No. 30 and 87. If continuity is not as specified, replace relay. If continuity is as specified, relay is okay at this time.