LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2001 >> Continental >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Anti-Theft Systems >> Power Door Locks & Remote Keyless Entry Systems >> Programming >> Keypad Programming

Keypad Programming

  1. Enter 5-digit manufacturer's permanent entry code at keypad. This code can be found on owner's wallet card in glove compartment, taped to computer module, interior of trunk or obtained from dealer. Within 5 seconds of pressing last digit, press 1/2 button on keypad to activate programming mode. Hold 1/2 button for more than 2 seconds to erase all stored customer codes. Doors will lock and unlock to confirm all codes are erased.
  2. Enter new 5-digit keypad code. To associate new code with personality position No. 1 or 2, press 1/2 button within 7.5 seconds of entering last digit of new code for position No. 1 or 3/4 button for position No. 2. Doors will lock and unlock to confirm new code is programmed. If another code is to be programmed, begin entering code within 7.5 seconds of pressing last button.
  3. After all new codes are programmed, a new remote transmitter code can be programmed within 7.5 seconds of pressing last digit in keypad code. To exit program mode, press keyless entry keypad buttons 7/8 and 9/0 simultaneously or wait 7.5 seconds for Driver's Door Module (DDM) to exit automatically.
scientia non olet · About LEMON Manuals