Test L: Doors Do Not Lock Using Remote Transmitter
- Operate power door locks using driver door lock control switch. If doors lock and unlock, go to next step. If doors do not lock and/or unlock, go to TEST C: ALL DOOR LOCKS INOPERATIVE USING DRIVER DOOR SWITCH .
- Connect New Generation Star (NGS) tester following manufacturers instructions. Turn ignition switch to RUN position. Monitor DDM FUNCTION TEST TIC/DATA while pressing LOCK and UNLOCK buttons on remote transmitter. If data received indicates LOCK and UNLOCK, replace DDM. See DRIVER DOOR MODULE (DDM) under REMOVAL & INSTALLATION. If data received does not indicate LOCK and UNLOCK, go to next step.
- Install NEW battery in remote transmitter. Monitor DDM FUNCTION TEST TIC/DATA while pressing LOCK and UNLOCK buttons on remote transmitter. If data received indicates LOCK and UNLOCK, test other remote transmitter functions. If all functions operate properly, system is okay at this time. If data received does not indicate LOCK and UNLOCK, go to next step.
- Program transmitters. See REMOTE TRANSMITTER under PROGRAMMING. Monitor DDM FUNCTION TEST TIC/DATA while pressing LOCK and UNLOCK buttons on remote transmitter. If data received indicates LOCK and UNLOCK, transmitter was not programmed. System is okay at this time. If data received does not indicate LOCK and UNLOCK, replace remote transmitter. Recheck system operation.