Programming New Restraints Control Module
NOTE:
When new Restraints Control Module (RCM) is installed in vehicle, it must be reprogrammed for applicable vehicle configuration.
- Ensure all air bag system components are properly installed and negative battery cable is connected. Connect scan tool to DLC. See USING SCAN TOOL . Turn ignition switch to RUN position. Follow scan tool manufacturer"s instructions to configure RCM for side air bag option required.
- For Continental with side air bags, select AIR BAG CONFIGURATION 12. For Continental without side air bags, select AIR BAG CONFIGURATION 13. Turn ignition off and remove scan tool. Prove out system. See PROVE OUT SYSTEM . If AIR BAG warning light flash codes are present during prove, go to diagnostic trouble code identification table for direction to appropriate test. See DIAGNOSTIC TROUBLE CODE (DTC) IDENTIFICATION table.