Memory Set Switch

Remove memory set switch and disconnect harness connector. Measure resistance between listed memory switch terminals with switch in each position. See MEMORY SET SWITCH RESISTANCE table. See Fig 1. If resistance is not as specified, replace memory switch.

MEMORY SET SWITCH RESISTANCE

Switch Position

Terminals No.

⁽¹⁾ Resistance (Ohms)

SET

1 & 6

Less Than 5

MEM 1

6 & 3

Less Than 5

MEM 2

6 & 4

Less Than 5

⁽¹⁾	Between terminals No. 8 and 9, resistance should be infinite. When ohmmeter leads are reversed, resistance should be low.

Fig 1: Identifying Memory Set Switch Terminals

Courtesy of FORD MOTOR CO.