Pinpoint Test F - Memory Mirrors Cannot Be Programmed

Memory Mirror System Voltage Check - Partially remove memory mirror module. Using a test light, backprobe Orange wire at memory mirror module Black connector. See Figure . If test light comes on, go to next step. If test light does not come on, repair open Orange wire. Retest system.
Ignition Input Check At Module - Turn ignition on. Using a test light, backprobe Red/Light Blue wire at memory mirror module Gray connector. See Figure . If test light comes on, go to next step. If test light does not come on, repair open Red/Light Blue wire. Retest system.
Circuit Check At Memory Mirror Module (Black Wire) - Check resistance between Black wire at memory mirror module Black connector and ground. See Figure . If resistance is 5 ohms or less, go to next step. If resistance is greater than 5 ohms, repair open Black wire. Retest system.
Input Check At Module (White/Orange Wire) - Check White/Orange wire for voltage memory mirror module Gray connector. See Figure . If voltage is 10 volts or greater, go to next step. If voltage is less than 10 volts, repair open White/Orange wire. Retest system.
Memory Switch Input To Module Test - Connect voltmeter to Brown/Light Green wire at memory mirror module Gray connector. See Figure . At driver's door front trim panel, press set button of memory seat regulator control. Within 5 seconds, press button No. 1 and read voltage. If voltage is 10 volts or greater, replace memory mirror module. Retest system. If voltage is less than 10 volts, go to next step.
Memory Switch Input Circuits Check - Turn ignition off. Unplug memory mirror module Gray connector. See Figure . Remove left memory seat regulator control. Check continuity of Brown/Light Green and Black/Orange wires between memory switch connector and 16-pin connector (Gray). If resistance is 5 ohms or less, replace mirror memory seat regulator control. Retest system. If resistance is greater than 5 ohms, repair open Brown/Light Green and/or Black/Orange wire(s). Retest system