Front Wheel Sensor: Removal
- From inside engine compartment, disconnect sensor electrical connector from right or left front sensor. Raise vehicle and disengage wire grommet at right or left shock tower and pull sensor cable connector through hole.
- Use care not to damage connector. Remove sensor wire from bracket on shock strut and side rail. Loosen 5 mm set screw holding sensor to sensor bracket post. Remove sensor through hole in disc brake splash shield. See Figure.
- To remove sensor bracket or sensor bracket post, in case of damage, caliper, hub and rotor assembly must be removed. After removing hub and rotor assembly, remove 2 brake splash shield attaching bolts which attach sensor bracket. If toothed sensor ring is damaged, replace it.