LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 1986 >> Mark VII Base >> Repair and Diagnosis >> Brakes >> Traction Control >> Anti-Lock >> Bleeding >> Bleeding System With Pressure Bleeder

Bleeding System With Pressure Bleeder

  1. When using a pressure bleeder, the bleeder must be attached to reservoir cap opening and a minimum of 35 psi (2.5 kg/cm2 ) must be maintained on system. With brake pedal released and ignition off, open rear caliper bleeder screws for 10 seconds at a time.
  2. Once an air-free flow of brake fluid has been observed at each caliper, close bleed screws and place ignition switch in "RUN" position. Pump brake pedal several times to complete bleed procedure. Siphon off excess fluid in reservoir to adjust level to "MAX" level with a fully charged accumulator.
scientia non olet · About LEMON Manuals