Potentiometer Test
- Using test light, test for continuity between potentiometer connector circuit 57 and switch bracket. If no continuity exists, replace potentiometer.
- Check continuity between circuits 220 and 57 of the potentiometer connector while rotating the switch from "OFF" to "ON".
- Check continuity between circuits 217 and 57 while rotating switch from "OFF" to maximum time delay. Resistance for these tests should gradually increase from 2500/4500 ohms at "OFF," to 140/260K ohms at maximum time delay.
- If potentiometer fails any of the preceding tests, replace the potentiometer assembly.NOTE: If any part of the control switch test is unsatisfactory, replace potentiometer.