DTC C1A06: Stop Light Switch Input Circuit [09/2014 - 11/2017]: Procedure

1. Clear the DTCs.

   Refer to DTC CHECK / CLEAR [09/2014 - 11/2017]

   Powertrain > Radar Cruise > Clear DTCs 

2. Make sure that the DTC detection conditions are met.

   HINT: 

   If the detection conditions are not met, the system cannot detect the malfunction.

3. Check for DTCs.

   Refer to DTC CHECK / CLEAR [09/2014 - 11/2017]

   Powertrain > Radar Cruise > Trouble Codes 

   NOTE:

   When replacing the driving support ECU assembly, always replace it with a new one. If a driving support ECU assembly which was installed to another vehicle is used, the information stored in the driving support ECU assembly will not match the information from the vehicle. As a result, a DTC may be stored.

   Result

   Result	Proceed to
   DTC C1A06 is not output	A
   DTC C1A06 is output	B

Result: 

A 

USE SIMULATION METHOD TO CHECK. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [09/2014 - 08/2016]  , or refer to  HOW TO PROCEED WITH TROUBLESHOOTING [08/2016 - 11/2017] 

Result: 

B 

REPLACE DRIVING SUPPORT ECU ASSEMBLY. Refer to  REMOVAL [09/2014 - 01/2023]