Installation [11/2021 - ]: Procedure
WARNING: This page is about a different car, the 2025 Lexus NX 350h, 2024 Lexus NX 350h, 2023 Lexus NX 350h, and 2022 Lexus NX 350h. However, it is still accessible from the selected car via links, so may be relevant.
- INSTALL KNOCK CONTROL SENSOR
*a Top *b Right of Vehicle *c 15° *d 5° - Install the knock control sensor to the cylinder block sub-assembly with the bolt so that the knock control sensor installation position is as shown in the illustration.
Torque: 20 N.m (204 kgf/cm, 15 ft.lbf)
NOTE:- If the knock control sensor has been struck or dropped, replace it.
- Make sure that the knock control sensor is in the correct position.
- Connect the knock control sensor connector.
- Install the knock control sensor to the cylinder block sub-assembly with the bolt so that the knock control sensor installation position is as shown in the illustration.
- INSTALL INTAKE MANIFOLD
Refer to INSTALLATION [11/2021 - ]
- PERFORM INITIALIZATION
- Perform "Inspection After Repair" after replacing the knock control sensor.
Refer to INITIALIZATION [11/2021 - ]
- Perform "Inspection After Repair" after replacing the knock control sensor.