Calibration [08/2020 - ]
- RESET MEMORY NOTE:
- Initial AWD functions such as acceleration are sometimes affected unless backup memory is cleared.
- When the yaw rate and acceleration sensor (airbag ECU assembly) is replaced, Reset Memory must be performed.
- Turn the engine switch off.
- Connect the Techstream to the DLC3.
- Turn the engine switch on (IG).
- Turn the Techstream on.
- Enter the following menus: Chassis / Four Wheel Drive / Utility / Reset Memory.
Chassis > Four Wheel Drive > Utility
Tester Display Reset Memory - Operate the Techstream to clear the data.