Typical Enabling Conditions
| Auxiliary battery voltage | 8 V or more |
| Engine switch | On (IG) |
| Starter | OFF |
| D range position switch | ON |
| R range position switch | OFF |
| Park position switch | OFF |
| Neutral position switch | OFF |
| Engine | Running |
| Pressure control solenoid circuit fail (P08CA, P08CB, P0962, P0963, P0966, P0967, P2826, P2827, P282F, P2830) (Pending + MIL) |
Not detected |
| Torque converter clutch pressure control solenoid circuit fail (P2763, P2764) (Pending + MIL) |
Not detected |
| Output speed sensor revolution | 380 rpm or more |
| Intermediate shaft speed sensor for belt drive revolution | 380 rpm or more |
| One of the following conditions is met | - |
| - Speed sensor monitor driving mode | Belt mode (Synchronizer engaged) |
| - Speed sensor monitor driving mode | Belt mode (Synchronizer released) |
One of the following conditions is met: Condition (A) or (B)
- CONDITION (A)
ECT 20°C (68°F) or higher ECT sensor circuit fail (P0117, P0118)
(Pending + MIL)Not detected All of the following conditions are met: 2 sec. or more - Park position switch OFF - Neutral position switch OFF CONDITION (B)One of the following conditions is met - - ECT Less than 20°C (68°F) - ECT sensor circuit fail (P0117, P0118)
(Pending + MIL)Detected All of the following conditions are met: 30 sec. or more - Park position switch OFF - Neutral position switch OFF