LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2022 >> RC F Base >> Repair and Diagnosis >> Electrical >> Starter >> Engine Starting System - Service Information >> Starter >> Installation [09/2014 - ] >> Procedure

Installation [09/2014 - ]: Procedure

  1. INSTALL FLYWHEEL HOUSING SIDE COVER 
    1. Install the flywheel housing side cover.
  2. INSTALL STARTER ASSEMBLY 
    1. Install the starter assembly with the 2 bolts.

      Torque: 37 N.m (377 kgf/cm, 27 ft.lbf) 

    2. Install the terminal cover with the nut.

      Torque: 10 N.m (102 kgf/cm, 7 ft.lbf) 

    3. Connect terminal 30 with the nut.

      Torque: 9.8 N.m (100 kgf/cm, 87 in.lbf) 

    4. Close the terminal cover.
    5. Connect the starter assembly connector.
  3. INSTALL NO. 3 EXHAUST MANIFOLD HEAT INSULATOR 
    1. Install the No. 3 exhaust manifold heat insulator with the 3 bolts.

      Torque: 11.5 N.m (117 kgf/cm, 8 ft.lbf) 

  4. INSTALL EXHAUST MANIFOLD SUB-ASSEMBLY RH 

    Refer to INSTALLATION [09/2014 - ]

  5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
    NOTE:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Refer to INITIALIZATION [09/2014 - 08/2016] , or refer to INITIALIZATION [08/2016 - 11/2017] , or refer to INITIALIZATION [11/2017 - 03/2019] , or refer to INITIALIZATION [03/2019 - 01/2023] , or refer to INITIALIZATION [01/2023 - 10/2023] , or refer to INITIALIZATION [10/2023 - ]

scientia non olet · About LEMON Manuals