DTC P2118: Throttle Actuator Control Motor Current Range / Performance [10/2015 - ]: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the power switch on (IG).
3. Turn the Techstream on.
4. Enter the following menus: Powertrain / Engine and ECT / Data List / +BM Voltage.

   Powertrain > Engine and ECT > Data List 

   Tester Display
   +BM Voltage

5. Read the value displayed on the Techstream.

   Result

   Result	Proceed to
   Less than 4 V	A
   11 to 16 V	B

Result: 

B 

CHECK FOR INTERMITTENT PROBLEMS. Refer to  CHECK FOR INTERMITTENT PROBLEMS [10/2015 - ] 

Result: 

A 

See step  2

1. Disconnect the ECM assembly connector.
2. Measure the voltage according to the value (s) in the table below.

   Standard Voltage

   Tester Connection	Condition	Specified Condition
   D1-30 (+BM) - Body ground	Always	11 to 16 V

3. Measure the resistance according to the value (s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   D1-29 (ME01) - Body ground	Always	Below 1 Ω
   D1-53 (E1) - Body ground	Always	Below 1 Ω

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE ECM ASSEMBLY. Refer to  REMOVAL [10/2015 - 08/2016]  , or refer to  REMOVAL [08/2016 - 03/2018]  , or refer to  REMOVAL [03/2018 - 08/2019]  , or refer to  REMOVAL [08/2019 - ] 

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR