Confirmation Driving Pattern

Stop the engine and allow it to soak.
Connect the Techstream to the DLC3.
Turn the power switch on (IG) and turn the Techstream on [A].
Enter the following menus: Powertrain / Engine and ECT / Data List / Coolant Temp and Intake Air.
Check that "Coolant Temp" is 56°C (133°F) or less and "Intake Air" is between 0 and 35°C (32 and 95°F).
Put the engine in inspection mode (maintenance mode).
Refer to INSPECTION MODE PROCEDURE [10/2015 - ]
Set the heater to MAX HOT with fresh air mode selected and turn the A/C off.
Start the engine.
With the engine running, drive the vehicle at 80 km/h (50 mph) for 15 minutes [B].
WARNING:
When performing the confirmation driving pattern, obey all speed limits and traffic laws.

HINT:

If the engine stops, further depress the accelerator pedal to restart the engine.
After "Coolant Temp" stabilizes, check that "Coolant Temp" is 75°C (167°F) or higher [C].
HINT:

If "Coolant Temp" is less than 75°C (167°F) while driving the vehicle at 80 km/h (50 mph), inspect the cooling system and thermostat.