DTC B2414: Steering Position Sensor [03/2019 - ]: Procedure

CLEAR DTC

Connect the Techstream to the DLC3.
Turn the engine switch on (IG).
Turn the Techstream on.
Enter the following menus: Body Electrical / HL AutoLeveling / Trouble Codes.

Clear the DTCs.

Body Electrical > HL AutoLeveling > Clear DTCs

Result

Proceed to
NEXT

Result:

NEXT

See step 2

CHECK FOR DTC

Connect the Techstream to the DLC3.
Turn the engine switch on (IG).
Turn the Techstream on.
Enter the following menus: Body Electrical / HL AutoLeveling / Trouble Codes.

Check for DTCs.

Body Electrical > HL AutoLeveling > Trouble Codes

OK

DTC B2414 is not output.

Result

Proceed to
OK
NG

Result:

OK

USE SIMULATION METHOD TO CHECK. Refer to HOW TO PROCEED WITH TROUBLESHOOTING [03/2019 - 09/2020] , or refer to HOW TO PROCEED WITH TROUBLESHOOTING [09/2020 - 01/2023] , or refer to HOW TO PROCEED WITH TROUBLESHOOTING [01/2023 - ]

Result:

NG

See step 3

REPLACE STEERING SENSOR

Replace the steering sensor with a new or known good one.

Refer to REMOVAL [09/2014 - ]

Result

Proceed to
NEXT

Result:

NEXT

See step 4

CLEAR DTC

Connect the Techstream to the DLC3.
Turn the engine switch on (IG).
Turn the Techstream on.
Enter the following menus: Body Electrical / HL AutoLeveling / Trouble Codes.

Clear the DTCs.

Body Electrical > HL AutoLeveling > Clear DTCs

Result

Proceed to
NEXT

Result:

NEXT

See step 5

CHECK FOR DTC

Connect the Techstream to the DLC3.
Turn the engine switch on (IG).
Turn the Techstream on.
Enter the following menus: Body Electrical / HL AutoLeveling / Trouble Codes.

Check for DTCs.

Body Electrical > HL AutoLeveling > Trouble Codes

OK

DTC B2414 is not output.

Result

Proceed to
OK
NG

Result:

OK

END (STEERING SENSOR WAS DEFECTIVE)

Result:

NG

REPLACE HEADLIGHT ECU SUB-ASSEMBLY LH. Refer to REMOVAL [03/2019 - ]