DTC C1AB6: Blind Spot Monitor Master Module [09/2014 - ]: Procedure

1. Clear the DTCs.

   Refer to DTC CHECK / CLEAR [09/2014 - ]

   Body Electrical > Blind Spot Monitor Master > Clear DTCs 

2. Recheck for DTCs and check if the same DTC is output again.

   Body Electrical > Blind Spot Monitor Master > Trouble Codes 

   OK

   No DTCs are output.

   Result

   Proceed to
   OK
   NG

Result: 

OK 

USE SIMULATION METHOD TO CHECK. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [09/2014 - 08/2016]  , or refer to  HOW TO PROCEED WITH TROUBLESHOOTING [08/2016 - 11/2017]  , or refer to  HOW TO PROCEED WITH TROUBLESHOOTING [11/2017 - 03/2019]  , or refer to  HOW TO PROCEED WITH TROUBLESHOOTING [03/2019 - 09/2020]  , or refer to  HOW TO PROCEED WITH TROUBLESHOOTING [09/2020 - 01/2023]  , or refer to  HOW TO PROCEED WITH TROUBLESHOOTING [01/2023 - ] 

Result: 

NG 

REPLACE BLIND SPOT MONITOR SENSOR LH. Refer to  REMOVAL [09/2014 - 03/2019]  , or refer to  REMOVAL [03/2019 - ]