Display Signal Circuit between Radio Receiver and Stereo Jack Adapter [09/2014 - 11/2017]: Procedure

1. Disconnect the O70 radio receiver assembly connector.
2. Disconnect the O66 No. 1 stereo jack adapter assembly connector.
3. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   O70-13 (VV+) - O66-8 (VV+)	Always	Below 1 Ω
   O70-14 (VV-) - O66-9 (VV-)	Always	Below 1 Ω
   O70-13 (VV+) - Body ground	Always	10 kΩ or higher
   O70-14 (VV-) - Body ground	Always	10 kΩ or higher
   O70-12 (SG) - Body ground	Always	10 kΩ or higher

   Result

   Proceed to
   OK
   NG

Result: 

OK 

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to  PROBLEM SYMPTOMS TABLE [09/2014 - 08/2016]  , or refer to  PROBLEM SYMPTOMS TABLE [08/2016 - 11/2017] 

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR