Installation [09/2015 - ]: Procedure

INSTALL POWER STEERING OIL PRESSURE SWITCH

Install a new O-ring to the oil pressure switch.
Apply a light coat of engine oil to the O-ring of the oil pressure switch.
NOTE:
- When reusing the oil pressure switch, inspect the O-ring.
- If the O-ring has scratches or cuts, replace the new O-ring.

Using a 24 mm deep socket wrench, install the oil pressure switch.

Torque: 21 N*m (214 kgf*cm, 15 ft.*lbf)

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

INSTALL FRONT HEIGHT CONTROL SENSOR SUB-ASSEMBLY RH

Install the sensor with the bolt and nut.

for bolt

Torque: 13 N*m (127 kgf*cm, 9 ft.*lbf)

for nut

Torque: 5.6 N*m (57 kgf*cm, 50 in.*lbf)

INSTALL FAN & GENERATOR V BELT
Refer to PROCEDURE - Step 1
INSTALL AIR CLEANER ASSEMBLY
Refer to PROCEDURE - Step 37
INSTALL AIR CLEANER HOSE ASSEMBLY
Refer to PROCEDURE - Step 10
ADD POWER STEERING FLUID
BLEED POWER STEERING FLUID
Refer to PROCEDURE - Step 3
INSPECT FOR POWER STEERING FLUID LEAK
INSTALL FRONT FENDER APRON TRIM PACKING A
Refer to PROCEDURE - Step 16
INSTALL FRONT WHEEL
Refer to PROCEDURE - Step 2
INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 19
INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH
Refer to PROCEDURE - Step 15
INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH
Refer to PROCEDURE - Step 16
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Refer to INITIALIZATION [09/2015 - 08/2019] , or refer to INITIALIZATION [08/2019 - ] ).
PERFORM VEHICLE HEIGHT OFFSET CALIBRATION
Refer to PROCEDURE - Step 4
ADJUST FRONT HEIGHT CONTROL SENSOR LINK SUB-ASSEMBLY
Refer to PROCEDURE - Step 1
PERFORM ZERO POINT CALIBRATION OF G SENSOR
Refer to PROCEDURE - Step 7
ADJUST HEADLIGHT ASSEMBLY
Refer to PROCEDURE - Step 8
INSTALL V-BANK COVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 69
INSTALL UPPER RADIATOR SUPPORT SEAL
Refer to PROCEDURE - Step 14