How To Proceed With Troubleshooting [10/2023 - ]: Procedure

Result

Result: 

NEXT 

See step  2

Standard voltage

11 to 14 V (Power switch off)

If the voltage is below 11 V, recharge or replace the auxiliary battery before proceeding.

Result

Result: 

NEXT 

See step  3

1. Use the Techstream to check if the CAN communication system is functioning normally.

   w/ Front LiDAR Sensor: Refer to DIAGNOSIS SYSTEM [10/2023 - ]

   w/o Front LiDAR Sensor: Refer to DIAGNOSIS SYSTEM [10/2023 - ]

   Result

   Result	Proceed to
   CAN DTCs are not output.	A
   CAN DTCs are output.	B

Result: 

B 

GO TO CAN COMMUNICATION SYSTEM 

w/ Front LiDAR Sensor: Refer to HOW TO PROCEED WITH TROUBLESHOOTING [10/2023 - ]

w/o Front LiDAR Sensor: Refer to HOW TO PROCEED WITH TROUBLESHOOTING [10/2023 - ]

Result: 

A 

See step  4

1. Check for DTCs.

   Refer to DTC CHECK / CLEAR [10/2017 - ] 

   Body Electrical > Tilt&Telescopic > Trouble Codes 

   Result

   Result	Proceed to
   DTCs are not output.	A
   DTCs are output.	B

Result: 

B 

GO TO DIAGNOSTIC TROUBLE CODE CHART. Refer to  DIAGNOSTIC TROUBLE CODE CHART [10/2023 - ]  

Result: 

A 

See step  5

1. Refer to Problem Symptoms Table.

   Refer to PROBLEM SYMPTOMS TABLE [10/2023 - ] 

   Result

   Result	Proceed to
   Problem symptom does not occur.	A
   Problem symptom occurs.	B

Result: 

B 

See step  7

Result: 

A 

See step  6

1. Terminals of ECU.

   Refer to TERMINALS OF ECU [10/2017 - ] 

2. Data List / Active Test.

   Refer to DATA LIST / ACTIVE TEST [10/2017 - ] 

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  7

Result

Result: 

NEXT 

See step  8

Result

Result: 

NEXT 

END