LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2021 >> LS 500 Base, AWD >> Repair and Diagnosis >> Electrical >> Starter >> Engine Starting System - Service Information >> Engine Switch >> Inspection [12/2017 - 10/2023] >> Procedure

Inspection [12/2017 - 10/2023]: Procedure

  1. INSPECT ENGINE SWITCH (PUSH START SWITCH) 
    1. Measure the resistance according to the value(s) in the table below.
      GTY796453Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Component without harness connected
      (Engine Switch (Push Start Switch))

      Standard Resistance

      Tester Connection Condition Specified Condition
      5 (SS1) - 6 (AGND)
      1 (SS2) - 6 (AGND)      		 Not pushed 10 kΩ or higher
      Pushed Below 1 Ω

      If the result is not as specified, replace the engine switch (push start switch).

    2. Apply battery voltage between the terminals of the engine switch, and check the illumination condition of the engine switch indicator light.

      OK

      Condition Specified Condition
      Battery positive (+) → Terminal 9 (SWIL)
      Battery negative (-) → Terminal 6 (AGND)      		 Illuminates

      HINT: 

      • If the positive (+) lead and the negative (-) lead are incorrectly connected, the engine switch indicator light will not illuminate.
      • If the voltage is too low, the engine switch indicator light will not illuminate.

      If the result is not as specified, replace the engine switch (push start switch).

      GTY796452Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Component without harness connected
      (Engine Switch (Push Start Switch))
scientia non olet · About LEMON Manuals