Pattern Select Switch Snow Mode Circuit [12/2017 - ]: Procedure

1. Inspect the No. 2 satellite switch set.

   Refer to INSPECTION [12/2017 - ]

   Result

   Proceed to
   OK
   NG

Result: 

NG 

REPLACE NO. 2 SATELLITE SWITCH SET. Refer to  REMOVAL [12/2017 - ] 

Result: 

OK 

See step  2

1. Disconnect the No. 2 satellite switch set connector.
2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   G59-7 (E) - Body ground	Always	Below 1 Ω

   Result

   Proceed to
   OK
   NG

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR 

Result: 

OK 

See step  3

1. Disconnect the ECM connector.
2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Switch Condition	Specified Condition
   A95-27 (SNWI) - Body ground	No. 2 satellite switch set knob turned and held at SNOW position	Below 50 Ω
   A95-27 (SNWI) - Body ground	No. 2 satellite switch set knob not turned to SNOW position	10 kΩ or higher

   Result

   Proceed to
   OK
   NG

Result: 

OK 

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to  PROBLEM SYMPTOMS TABLE [12/2017 - ] 

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR