DTC C1595: Lost Communication with Steering Angle Sensor Module(SIL); DTC C15C4: Steering Signal Not Detected [09/2018 - ]: Procedure
- CHECK DTC
- Check for DTCs.
Refer to DTC CHECK / CLEAR [09/2018 - ]
Chassis > VGRS > Trouble Codes
Result
Result Proceed to DTCs C15C1, C15C2 and U0126 are not output A DTCs C15C1, C15C2 and U0126 are output B
Result:
B
REPAIR CIRCUITS INDICATED BY OUTPUT DTCS. Refer to DIAGNOSTIC TROUBLE CODE CHART [09/2018 - ]
Result:
A
See step 2
- Check for DTCs.
- CHECK HARNESS AND CONNECTOR (VGRS ECU (FRONT STEERING CONTROL ECU) - STEERING SENSOR)
- Turn the power switch off.
- Disconnect the P72 VGRS ECU (front steering control ECU) connector.
- Disconnect the P22 steering sensor connector.
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition P72-5 (SS1-) - P22-10 (SS2-) Always Below 1 Ω P72-6 (SS1+) - P22-5 (SS2+) Always Below 1 Ω P72-5 (SS1-) or P22-10 (SS2-) - Body ground Always 100 kΩ or higher P72-6 (SS1+) or P22-5 (SS2+) - Body ground Always 100 kΩ or higher P72-5 (SS1-) - P72-6 (SS1+) Always 1000 kΩ or higher Result
Proceed to OK NG
Result:
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
Result:
OK
See step 3
- CHECK STEERING SENSOR
- Reconnect the P72 VGRS ECU (front steering control ECU) connector.
*a Component with harness connected
(VGRS ECU [Front Steering Control ECU]) - Reconnect the P22 steering sensor connector.
- Turn the power switch on (READY).
- Measure the voltage according to the value(s) in the table below.
HINT:
With the connector connected to the VGRS ECU (front steering control ECU), measure the voltage from the rear of the connector.
Standard Voltage
Tester Connection Condition Specified Condition P72-5 (SS1-) - Body ground Steering wheel rotated slowly Pulse waveform that alternates between 0 and 5 V is output P72-6 (SS1+) - Body ground Result
Proceed to OK NG
Result:
OK
REPLACE VGRS ECU (FRONT STEERING CONTROL ECU). Refer to REMOVAL [01/2017 - 05/2023] , or refer to REMOVAL [05/2023 - ]
Result:
NG
REPLACE STEERING SENSOR. Refer to REMOVAL [01/2017 - 05/2023] , or refer to REMOVAL [05/2023 - ]
- Reconnect the P72 VGRS ECU (front steering control ECU) connector.