Steering Angle Differs between Left and Right [01/2017 - 09/2018]: Procedure

1. Check for DTCs in the dynamic rear steering system.

   Refer to DTC CHECK / CLEAR [01/2017 - 09/2018]

   Chassis > DRS > Trouble Codes 

   Result

   Result	Proceed to
   DTCs are not output	A
   DTCs are output	B

Result: 

B 

GO TO DYNAMIC REAR STEERING SYSTEM (DIAGNOSTIC TROUBLE CODE CHART). Refer to  DIAGNOSTIC TROUBLE CODE CHART [01/2017 - 09/2018] 

Result: 

A 

See step  2

1. Check for DTCs.

   Refer to DTC CHECK / CLEAR [01/2017 - 09/2018]

   Chassis > VGRS > Trouble Codes 

   Result

   Result	Proceed to
   DTC is not output	A
   DTC is output	B

Result: 

B 

GO TO DIAGNOSTIC TROUBLE CODE CHART. Refer to  DIAGNOSTIC TROUBLE CODE CHART [01/2017 - 09/2018] 

Result: 

A 

See step  3

1. Check the neutral position of the steering wheel.

   Result

   Result	Proceed to
   Steering wheel is centered	A
   Steering wheel is off-center	B

Result: 

B 

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to  PROBLEM SYMPTOMS TABLE [01/2017 - ] 

Result: 

A 

See step  4

1. Position the tires straight ahead.
2. Turn the power switch off.
3. Disconnect the steering actuator assembly connector.
4. Turn the power switch on (READY), turn the steering wheel from lock to lock and check the left and right steering angle.

   OK

   No steering angle difference between left and right.

   HINT: 

   When the vehicle is driven with the steering actuator assembly connector disconnected, DTC C15A5/65 is stored. After performing the inspection, clear DTCs.

   Refer to DTC CHECK / CLEAR [01/2017 - 09/2018]

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE STEERING ACTUATOR ASSEMBLY. Refer to  REMOVAL [01/2017 - 05/2023] 

Result: 

NG 

CHECK AND REPAIR OR REPLACE STEERING-RELATED PARTS (STEERING GEAR, STEERING COLUMN, ETC.)