DTC C1AB6: Blind Spot Monitor Master Module [01/2017 - ]: Procedure

1. Turn the power switch off.
2. Turn the power switch on (IG).
3. Recheck for DTCs and check if the same DTC is output again.

   Body Electrical > Blind Spot Monitor Master > Trouble Codes 

   OK

   No DTCs are output.

   Result

   Proceed to
   OK
   NG

Result: 

OK 

USE SIMULATION METHOD TO CHECK. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [01/2017 - 04/2020]  , or refer to  HOW TO PROCEED WITH TROUBLESHOOTING [04/2020 - 05/2023]  , or refer to  HOW TO PROCEED WITH TROUBLESHOOTING [05/2023 - ] 

Result: 

NG 

REPLACE BLIND SPOT MONITOR SENSOR RH. Refer to  REMOVAL [01/2017 - ]