DTC P1023: Camshaft Position Signal Output "B" Circuit; DTC P2614: Camshaft Position Signal Output Circuit / Open [07/2020 - ]: Procedure

1. Replace the camshaft timing control motor with EDU assembly.

   Refer to REMOVAL [07/2020 - 05/2023] , or refer to REMOVAL [05/2023 - ]

   HINT: 

   Perform "Inspection After Repair" after replacing the camshaft timing control motor with EDU assembly.

   Refer to INITIALIZATION [07/2020 - ]

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  2

1. Connect the Techstream to the DLC3.
2. Turn the engine switch on (IG).
3. Turn the Techstream on.
4. Clear the DTCs.

   Powertrain > Engine > Clear DTCs 

5. Turn the engine switch off and wait for at least 30 seconds.

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  3

1. Drive the vehicle in accordance with the driving pattern described in the Confirmation Driving Pattern.
2. Enter the following menus: Powertrain / Engine / Trouble Codes.

   Powertrain > Engine > Trouble Codes 

3. Read the DTCs.

   Result

   Result	Proceed to
   DTCs are not output	A
   DTC P1023 and/or P2614 is output	B

Result: 

A 

END 

Result: 

B 

REPLACE ECM. Refer to  REMOVAL [07/2020 - 05/2023]  , or refer to  REMOVAL [05/2023 - ]